KINGSTON 2GB 1333MHz DDR3 1333 240 pin UDIMM Dekstop Value RAM KVR13N9S6/2

Product Detail KINGSTON 2GB DDR3-1333 UDIMM PC3-10600 CL9 240-pin RAM KVR13N9S6/2

DESCRIPTION

This document describes ValueRAM's 256M x 64-bit (2GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM) 1Rx16, memory module, based on four 256M x 16-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:

FEATURES

• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

• VDDQ = 1.5V (1.425V ~ 1.575V)

• 667MHz fCK for 1333Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 9, 8, 7, 6

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C

• Asynchronous Reset

• PCB : Height 1.180” (30.00mm), single sided component

SPECIFICATIONS

CL(IDD)                                                                                   9 cycles

Row Cycle Time (tRCmin)                                                      49.125ns (min.)

Refresh to Active/Refresh                                                      260ns (min.)                                                              Command Time (tRFCmin)

Row Active Time (tRASmin)                                                  36ns (min.)

Maximum Operating Power                                                   1.050 W*

UL Rating                                                                               94 V - 0

Operating Temperature                                                          0o C to 85o C

Storage Temperature                                                             -55o C to +100o C

*Power will vary depending on the SDRAM used.